12
Superior Broadcast
ATVCA Amplifier User Manual
Superior Broadcast ATVCA Amplier
5. Setting
5.1 Setting on air
1. Connect the RF output power of a suitable TV exciter (e.g. the DTVPE of
R.V.R. Elettronica) to the RF input (RF module) using a cable tted with N type
connectors. The exciter should be set to minimum output power and switched
OFF.
2. Connect the amplier’s INTERLOCK output connector to the exciter’s Interlock
input, if available (it is available in all RVR Elettronica exciters) using a twin
wire with BNC connectors.
Note: the amplier’s INTERLOCK output connector is an output signal on coaxial
BNC type connector. The operating logic is as follows: the internal conductor
is oating when the amplier works correctly, else is closed to GND. When
INTERLOCK signal is closed to GND, RF output power from exciter MUST shut
down.
3. Connect the RF output to the antenna system cable suitable to stands the
RF output power of the amplier (antenna system means RF ouput lter and
antenna feeder).
5.2 Setting on lab
1. Perform connections described in the previous chapter from point 1 to point
2.
2. Connect the RF output to a dummy load suitable to stands the RF output power
of the amplier.
10 / 32
User Manual
Rev. 1.0 - 22/11/10
Comments to this Manuals