Instruction ManualSCT2x4 Headend Transcoder - 2 Sat / 4 QAMis a registered trademark of the R.L. Drake Holdings LLC© Copyright 2012 R. L. Drake Holdin
10Additional InformationSTANDBY MODEThe SCT2x4 has a standby output mode which turns off the RF output. This can be used when it is desirable to tempo
11CATV Channel Frequencies
12THIS PAGE INTENTIONALLY LEFT BLANKHRC Channel Frequencies
13 IRC Channel Frequencies
14Broadcast TV Channel Frequencies
15Service / If You Need To Call For HelpSERVICE INFORMATIONYou may contact the R.L. DRAKE Service Department for additional information or assistance
16If You Need To Call For Help (continued)If the unit is out of warranty, use one of the following methods for return shipment:1) You designate billin
17Three Year Limited WarrantyR.L. DRAKE HOLDINGS LLC warrants to the original purchaser this product shall be free from defects in material or workman
R.L. Drake Holdings, LLC 710 Pleasant Valley DriveSpringboro, OH 45066(937) 746-4556www.rldrake.com
2Table of Contents, Caution, & Important Safety InstructionsCAUTION STATEMENTS ...
3Important Safety Instructions (continued)8. Accessories: Do not place this product on an unstable cart, stand, tripod, bracket, or table. The produc
4SpecicationsRF OUTPUTImpedance: 75 ohmsData Rate: 270 Mb/sFrequency range: 54 MHz to 1002 MHz. Standard CATV, HRC, IRC, or Broadcast channel plans
52 SATELLITE DEMODSThe SCT2X4 is a Satellite to Cable Transcoder that includes two satellite tuners and demodulators that are independently tuned and
6INSTALLATION AND MOUNTING NOTESThis equipment is designed to be installed in a standard 19” rack. When the unit is mounted above or below other rack
7Rear Panel ConnectionsR1, RF OUTPUT – This type "F" connector is the high level (+55 dBmV), 54 to 1002 MHz, output from the SCT2x4 upconver
8Setup and Programming / Software Flow ChartProgramming and viewing of the various setup and operating parameters is accomplished using the front pane
9Setup and Programming (continued)This section provides additional details regarding the selectable items shown in the ‘adjust’ mode on the Software
Comments to this Manuals